Table of Contents
Advertisement
Note: If you send a fax in superfine, certain fax models (especially older,
non-Pitney Bowes models) will receive it only in fine mode.
However, you can send a fax in gray-scale mode to virtually any
fax machine currently in use.
Note: If making a copy, you may select only the Superfine or Grayscale
resolution.
To change the resolution setting, press RESOLUTION
repeatedly. As noted above, if neither the FINE, S-FINE
nor GRAYSCALE LED (light-emitting diode; in this case,
a small green light) is glowing, your fax is set for normal
resolution. Otherwise, a glowing LED indicates the fax is
using the setting named by that LED. For example, in the
drawing (left), the machine is set for fine resolution.
Contrast
Setting the contrast allows you to compensate for any excessive lightness
or darkness, as the case may be, of document pages you are sending or
copying.
To change the contrast setting:
1. Press CONTRAST on the control panel. The display, or LCD (liquid
crystal display), indicates the current contrast setting.
Set Contrast
Light
2. To adjust the contrast setting, press
To light up an overly dark document, press
To darken an overly weak document, press
Here are the possible settings:
Set Contrast
Light
Light — Lightens up overly dark originals.
Set Contrast
Light
Provides some lightening of originals.
Set Contrast
Light
Normal — Suited to most documents.
• •
H
• •
Dark
,
or CONTRAST.
• •
H
• •
Dark
• •
H
• •
Dark
• •
H
• •
Dark
48
.
.
Advertisement
Table of Contents
