Table of Contents
Advertisement
The main idea is: when it's time within an operation for entering the fax
number to which you are to send your document, you enter multiple
numbers until you've either reached 220 numbers or finished dialing all
you want to dial for this document.
Delayed broadcasting
What if you want the broadcast to happen later? That's the purpose of
setting up a delayed broadcast.
Note: Actually, we're jumping the gun a bit here; the main discussion of
delayed commands comes up in "Delayed transmission" (pages
117-122). You may wish to read that material before proceeding.
1. [Same as steps 1-5 of "The basics of broadcasting" (previous page).]
2. Press COMMUNICATION OPTIONS, ENTER.
3. Use the numeric keypad to enter the day of the month and time when
you want the fax to perform the broadcast. Here, we've set it to occur
at 10:15 p.m. on the 17th.
Delayed
Enter Time: 17/22:15
When the entry is complete, press ENTER.
4. Press START. Your machine will return to its normal standby mode,
while showing this on the display.
Sep 27 1998
This means your fax machine is "reserved" for the delayed broadcast
you just programmed.
If you have set the machine for memory transmission (see page 50)
from the ADF, it will scan the document into memory, after which you
can use the machine normally.
If you have set the machine for non-memory transmission from the
ADF, the machine can receive faxes but can't transmit until after the
delayed broadcast occurs.
Note: Transmission from the FBS is always memory transmission.
** Reserved **
17:17
113
Advertisement
Table of Contents
