Table of Contents
Advertisement
18. The display now shows:
03: Set F-Code Box
F-Code Passcode : 0000
The machine is asking for this bulletin box's four-digit security
passcode.
This passcode affects only the box's bulletin box capabilities, and is
not the same passcode you entered in steps 6-7. If you set this
passcode, you subsequently will have to enter the passcode before you
can make any changes to the box's security box settings or before you
either can print or view any document received in this bulletin box.
If you do wish to enter or change this passcode, proceed to step 19.
If this is a newly created box and you do not wish to enter this
passcode, enter 0000 (four zeros), then skip to step 21.
If this is a previously created box and you do not wish to change this
passcode, skip to step 21.
19. Decide upon, and then write down, a four-digit passcode (0000-9999)
for this bulletin box and put it in a safe place.
Important: Do not use 0000 as a passcode. This disarms protection
for this box.
20. Use the numeric keypad to enter the four-digit passcode for this
bulletin box.
Important: After you proceed with step 21, one must know this
passcode to access this F-Code box.
21. Press ENTER to save this bulletin box information.
To create or modify another F-Code box, repeat steps 4-16 (and then
either 17-21 or 22-26, depending upon the type of box it is or will be).
To finish, press STOP. Now see "Using a bulletin box" (pages 191-
195).
Important: The remaining steps, 22-26, are about only setting an F-
Code box to be a security box. If you are interested in
only the bulletin box feature, you may skip these steps.
187
Advertisement
Table of Contents
