Table of Contents
Advertisement
11. A number's Location ID may be up to 24 characters in length. You
enter the Location ID the same way you entered your fax name
during EasyStart. We'll review the process, here. (If you're changing a
previously entered Location ID, see the note at the end of this step.)
Important: As in EasyStart, you enter letters and other non-
numeric characters through the one-touch keys.
005:Name
_
The word "Upper" means the machine is currently set for entering
only upper-case letters. If you press R, the machine will see it as an R
(not an r).
To change it so that pressing a one-touch key will produce a lower-
case letter rather than an upper-case letter, press ALPHABET. The
display will change to:
005:Name
_
This means pressing one-touch keys will enter lower-case letters:
pressing R will produce an r (not an R) on the display.
To switch back for upper-case entries, press ALPHABET again.
To enter spaces, punctuation and symbols, enter the characters shown
on the one-touch keypad you want.
To use CODE to enter a wide variety of characters, please review the
explanation on page 80. The vast majority of the time, you will
probably find the ALPHABET key to be sufficient.
Note: If you make a mistake or want to erase characters entered in
a previous setting, press CANCEL to erase leftward. Or, if
you want to change just one character in the number, press
to move the cursor leftward, or
that character and press CANCEL to erase it. Then re-enter
until the number is just as you want it.
12. Press ENTER to save the setting and continue.
:Upper
:Lower
to move it rightward, to
102
Advertisement
Table of Contents
