Programmable One-Touch Fax Dialing - Pitney Bowes 4100 Operator's Manual

Programmable one-touch fax dialing

To dial a fax call using a programmable one-touch number:
1. If the machine is in Fax mode, proceed to step 2.
If it is in Copy mode, press COPY/FAX to change to Fax mode.
2. Insert the document.
3. Adjust resolution and contrast if necessary.
4. Toggle between transmission from the feeder or from memory if
necessary, by pressing MEMORY TRANSMIT.
Note: This toggle affects only a transmission from the ADF.
Transmission from the FBS is always memory transmission.
5. Press the programmable one-touch key in which you've stored the
number.
The machine will handle the call from here, performing the operation
you've programmed either now or later, depending on what you
specified.
Note: To review the details of each available operation please review
its appropriate area in these instructions. See page 202 for a
list of where you may find each operation.
If you programmed this key to delay its operation, the display will
show:
LTLG
However, if you programmed this key to perform the operation
immediately after the key press, the display will show the number:
9-1-972-555-4335
LTLG
** Reserved **
Mem95%
Mem95%
224