Programming F-Code Polling - Pitney Bowes 4100 Operator's Manual

Programming F-Code polling

Note: To erase a programmable one-touch key, see page 225.
Note: For this operation to work, two things must be true:
• The document which you're polling must exist on the remote
machine in an F-Code box.
• You must know remote fax's ITU-T sub-address and (if
applicable) password number for each box to which you wish to
transmit.
To program an F-Code transmitting operation into a programmable one-
touch key:
1. Press PROGRAM, C, 1, ENTER. The display either shows:
Select Program No.
73: No Number Stored
... or indicates a command already is programmed into this key. If 73
is the key you want to program, skip to step 4. (However, our
examples from here on will say 74 rather than 73.
2. Select the key into which you want to program a command or change
a previously stored command — if necessary, turn the fliptab to see it,
as described earlier — and then press it. Here, we've selected 74.
Select Program No.
74: No Number Stored
3. If you change your mind and wish to select a different programmable
one-touch key, go back to step 2 before going on to step 4.
4. Press ENTER. The display now shows either:
74: Fax Number
_
74: Fax Number
or
9-5557312_
221