Table of Contents
Advertisement
If you've specified "Mode1" — the PIN goes in
In this mode, before autodialing the desired number the first time, you must
add the PIN to its stored one-touch key or speed-dial number. Here's how:
1. Make a normal autodialer entry through the entry of the call group(s).
The display will show:
Set PIN Number
Enter Passcode : ****
2. Use the numeric keypad to enter the four-digit passcode. Here, we'll use
our sample passcode again:
Set PIN Number
Enter Passcode : 6296
3. Press ENTER. In our example, we're setting speed-dial number 001:
001:PIN Number
_
4. Use the numeric keypad (including either * or #, if necessary) to enter
the desired PIN, up to eight characters in length.
001:PIN Number
1057_
5. Press ENTER to save the PIN.
Note: If you press ENTER without entering the PIN, the fax machine
beeps, indicates "Invalid Number" on the display and then
returns you to step 3.
Now you may autodial the number as usual.
Important:
While in PIN Mode 1, any autodialer numbers you use must
include the PIN. Thus, this applies also to autodialer
numbers used with batch transmission (see page 90) or
programmable one-touch keys (see page 123).
Note:
If you select either Mode 1 or Mode 2 and will be using batch
transmission (see page 202), you must store the PIN access
code for the remote unit within the appropriate batch box.
164
Advertisement
Table of Contents
