Programming F-Code Transmission - Pitney Bowes 4100 Operator's Manual

Programming F-Code transmission

Note: To erase a programmable one-touch key, see page 225X.
Note: For this operation to work, two things must be true:
• You must know how the remote fax is using each F-Code
(ITU-T-standard sub-addressing/password) box to which you're
transmitting — as a bulletin box or as a security box
(obviously, different makers may use slightly different terms,
but the concepts are the same).
• You must know remote fax's ITU-T sub-address and password
number for each box to which you wish to transmit.
To program an F-Code transmission into a programmable one-touch key:
1. Change to the Fax mode then press PROGRAM, C, 1, ENTER. The
display either shows:
Select Program No.
73: No Number Stored
... or indicates a command already is programmed into this key. If 73
is the key you want to program, skip to step 4. (However, our
examples from here on will say 74 rather than 73.
2. Select the key into which you want to program a command or change
a previously stored command — if necessary, turn the fliptab to see it,
as described earlier — and then press it. Here, we've selected 74.
Select Program No.
74: No Number Stored
3. If you change your mind and wish to select a different programmable
one-touch key, go back to step 2 before going on to step 4.
4. Press ENTER. The display now shows either:
74: Fax Number
_
74: Fax Number
or
9-5557312_
218