Table of Contents
Advertisement
9. An F-Code box's name may be up to 16 characters in length. You enter
the name the same way you entered your fax name during EasyStart.
We'll review the process, here. (If you're changing a previously
entered name, see the note at the end of this step.)
Important: As in EasyStart, you enter letters and other non-
numeric characters through the one-touch keys.
3: Box Name
_
The word "Upper" means the machine is currently set for entering
only upper-case letters. If you press R, the machine will see it as an R
(not an r). To change it so that pressing a one-touch key will produce a
lower-case letter rather than an upper-case letter, press ALPHABET.
The display will change to:
3: Box Name
_
This means pressing one-touch keys will enter lower-case letters:
pressing R will produce an r (not an R) on the display.
To switch back for upper-case entries, press ALPHABET again.
To use CODE to enter a wide variety of characters, please review the
explanation on page 80. The vast majority of the time, you will
probably find the ALPHABET keys to be sufficient.
Note: If you make a mistake or want to erase characters entered in
a previous setting, press CANCEL to erase leftward. Or, if
you want to change just one character in the name, press
move the cursor leftward, or
character and press CANCEL to erase it. Then re-enter until
the name is just as you want it.
10. Press ENTER to save the box's name and continue. The display
shows either:
03: Sub-Address No.
_
The machine is asking for this F-Code box's sub-address. This ITU-T-
standard, all-numerical identifier is essential for F-Code
communication. You must enter one to use this F-Code box, and
anyone trying to fax to this F-Code box must know it.
To enter or change the sub-address number, proceed to step 1.
If you do not wish to change an existing sub-address number, skip to
step 12.
:Upper
:Lower
to move it rightward, to that
03: Sub-Address No.
or
123456_
182
to
Advertisement
Table of Contents
