Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 246

show spantree vlan ports
Spanning Tree Port Summary for Vlan 12
Oper Path
Port St Cost
-----+----+-------+-------+----+-----+---+---+----------------------+---------
1/42 DIS
1/43 DIS
Spanning Tree Port Summary for Vlan 13
Oper Path
Port St Cost
-----+----+-------+-------+----+-----+---+---+----------------------+---------
1/38 DIS
output definitions
Vlan
Port
Oper St
Path Cost
Desig Cost
Role
Prim. Port
Op Cnx
Op Edg
Desig Bridge ID
page 5-104
Desig Prim. Op
Cost Role Port
0 0 DIS 1/42
0 0 DIS 1/43
Desig Prim. Op
Cost Role Port
0 0 DIS 1/38
The VLAN ID associated with the VLAN Spanning Tree instance.
Configured through the
The slot number for the module and the physical port number or a logi-
cal port. If the slot number is 0, then the port number refers to a link
aggregate logical port number (e.g., 0/31).
The port operational state as defined by application of the Spanning
Tree Protocol. Possible port operational states include: disabled, block-
ing, listening, learning, and forwarding.
The contribution of this port to the path cost towards the Spanning Tree
root bridge that includes this port. Path cost is a measure of the distance
of the listed port from the root bridge in the number of hops. Config-
ured through the
The path cost of the Designated Port of the segment connected to this
port. If this is the root bridge or the Spanning Tree status of the port is
administratively disabled, this value is 0.
The role of the port for this Spanning Tree instance. Possible port roles
are: root, designated, alternate, master, and backup.
The slot number for the module and the physical port number on that
module for the primary port associated with this Spanning Tree
instance. This information is only available if the port role is backup.
Operational connection type: PTP, NPT, or NS (nonsignificant).
Shows the current operational state of the port's connection type. See
the spantree vlan connection
Operational connection type: EDG. Shows the current operational state
of the port's connection type. See the
mand for more information.
The bridge identifier for the designated bridge for this port's segment.
Distributed Spanning Tree Commands
Op
Cnx Edg Desig Bridge ID
NS EDG 0000-00:00:00:00:00:00
NS NO 0000-00:00:00:00:00:00
Op
Cnx Edg Desig Bridge ID
NS EDG 0000-00:00:00:00:00:00
vlan commands
spantree vlan path-cost
command for more information.
OmniSwitch CLI Reference Guide
Note
Note
command.
spantree vlan connection
March 2011
com-