Enable Netlogin Session-Refresh - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Network Login Commands

enable netlogin session-refresh

enable netlogin session-refresh {<minutes>}
Description
Disables network login session refresh.
Syntax Description
minutes Specifies the session refresh time for network login in minutes.
Default
Disabled, with a value of three minutes for session refresh.
Usage Guidelines
Network Login sessions can refresh themselves after a configured timeout. After the user has been
logged in successfully, a logout window opens which can be used to close the connection by clicking on
the Logout link. Any abnormal closing of this window is detected on the switch and the user is logged
out after a time interval as configured for session refresh. The session refresh is enabled and set to three
minutes by default. The value can range from 1 to 255 minutes. When you configure the network login
session refresh for the logout window, ensure that the FDB aging timer is greater than the network login
session refresh timer.
This command applies only to the web-based authentication mode of network login.
To reset the session refresh value to the default behavior, use this command without the
minutes
parameter.
Example
The following command enables network login session refresh and sets the refresh time to ten minutes:
enable netlogin session-refresh 10
History
This command was first available in ExtremeWare XOS 11.1.
Platform Availability
This command is available on all platforms.
1088
ExtremeWare XOS 11.5 Command Reference Guide