Configure Eaps Config-Warnings On - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

configure eaps config-warnings on

configure eaps config-warnings on
Description
Enables the loop protection warning messages displayed when configuring specific EAPS parameters.
Syntax Description
This command has no arguments or variables.
Default
By default, loop protection warnings are enabled and displayed when configuring specific EAPS
parameters.
Usage Guidelines
This is a global EAPS command. You configure the warning message display on a per switch basis, not
per EAPS domain.
When configuring the following EAPS parameters, the switch displays loop protection warning
messages:
Adding EAPS primary or secondary ring ports to a VLAN
●
Deleting a protected VLAN
●
Disabling the global EAPS setting on the switch
●
Disabling an EAPS domain
●
Configuring an EAPS domain as a transit node
●
Unconfiguring EAPS primary or secondary ring ports from an EAPS domain
●
Extreme Networks recommends that you keep the loop protection warning messages enabled.
Example
The following command enables the loop protection warning messages:
configure eaps config-warnings on
History
This command was first available in ExtremeWare XOS 11.4.
Platform Availability
This command is available on all platforms.
ExtremeWare XOS 11.5 Command Reference Guide
configure eaps config-warnings on
1119