Uninstall Image - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

uninstall image

uninstall image <fname> <partition> {msm <slotid>} {reboot}
Description
Uninstalls an ExtremeWare XOS software package.
Syntax Description
fname
partition
slotid
reboot
Default
N/A.
Usage Guidelines
Use this command to uninstall a software package previously installed on the switch.
When you uninstall a software package, the switch prompts you to save your changes to your currently
active configuration file:
Uninstallation of the
Do you want to save configuration changes to primary.cfg? (y or n)
Enter to save the changes to your configuration file. Enter
y
configuration file.
Local Filename Character Restrictions. This section provides information about the characters supported
by the switch for local and remote filenames.
When specifying a local filename, the switch permits only the following characters:
Alphabetical letters, upper case and lower case (A-Z, a-z)
●
Numerals (0-9)
●
Period ( . )
●
Dash ( - )
●
Underscore ( _ )
●
ExtremeWare XOS 11.5 Command Reference Guide
Specifies the software package to uninstall.
Specifies which partition the package was installed to: primary or secondary.
Select primary to remove it from the primary partition and secondary to remove
it from the secondary partition.
Specifies the MSM where the package should be uninstalled.
• A specifies the MSM installed in slot A.
• B specifies the MSM installed in slot B.
NOTE: This parameter is available only on modular switches.
Reboots the switch after the package is uninstalled.
EXOS module
to not save the changes to your
n
uninstall image
1935