Extreme Networks ExtremeWare XOS Command Reference Manual page 1982

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Troubleshooting Commands
Action
Example
The following command displays summary ELRP status information on the switch:
show elrp
The following sample output is displayed:
ELRP Standalone Client:
Number of ELRP sessions:
Number of ELRP pkts transmitted:
Number of ELRP pkts Received:
Client Vlan
--------------------------------------------------------------------------
CLI Default
--------------------------------------------------------------------------
Action : (P) Print , (L) Log , (T) Trap , (C) Callback
History
This command was first available in ExtremeWare XOS 11.1.
Platform Availability
This command is available on all platforms.
1982
Displays the configured action the switch takes when ELRP messages are received back
indicating a detection of a network loop or no packets are received within the specified
duration.
The following list describes the actions:
• Print (P)—Specifies that the switch prints a message to the console.
• Log (L)—Specifies that the switch sends a message to the system log file.
• Trap (T)—Specifies that the switch sends a message to the SNMP manager.
• Callback (C)—Specifies a callback action. If you use ELRP with another protocol (for
example ESRP), ELRP uses a callback action to notify the protocol of a loop detection.
Enabled
1
3288
0
Ports Int. Count Cyclic Pkts-Xmit Pkts-Rcvd Action
All 1 0 Yes 3288
ExtremeWare XOS 11.5 Command Reference Guide
0 LT