Extreme Networks ExtremeWare XOS Command Reference Manual page 1150

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
EAPS Commands
Hello Timer interval:
Fail Timer interval:
Failtimer expiry action:
Preforwarding Timer interval:
Last update:
EAPS Domain has ... Controller
Vlans:
EAPS Domain has ... Protected
b
Vlans:
Number of Protected Vlans:
a. These fields apply only to transit nodes; they are not displayed for a master node.
b. This list is displayed when you use the detail keyword in the
Example
The following display shows sample output for the command
EAPS Enabled: Yes
EAPS Fast-Convergence: Off
EAPS Display Config Warnings: On
Number of EAPS instances: 2
# EAPS domain configuration :
--------------------------------------------------------------------------------
Domain
--------------------------------------------------------------------------------
d1
d2
--------------------------------------------------------------------------------
The following display shows sample output for the command
Name: d1
State: Complete
Enabled: Yes
Primary port:
Secondary port: 3:16
Hello timer interval: 1
Fail timer interval:
Fail Timer expiry action: Send alert
Last update: From Master Id 00:01:30:f9:9c:b0, at Wed Jun
EAPS Domain has following Controller Vlan:
Vlan Name
c1
1150
The configured value of the timer in seconds, specifying the time that the
master node waits between transmissions of health check packets.
The configured value of the timer in seconds, specifying the time that the
master node waits before the failtimer expires.
Displays the action taken when the failtimer expires:
• Send-alert—Sends a critical message to the syslog when the failtimer
expires.
• Open-secondary-port—Opens the secondary port when the failtimer expires.
Displays only for master nodes.
a
The configured value of the timer. This value is set internally by the EAPS
software. The set value is 15 seconds.
Note: If two links in an EAPS domain go down at the same time and one link
comes back up, it will take 15 seconds for the reconnected link to start
receiving traffic again.
Indicates the last time a hello packet is received from the master node.
Lists the assigned name and ID of the control VLAN.
Lists the assigned names and VLAN IDs of all the protected VLANs configured
on this EAPS domain.
The count of protected VLANs configured on this EAPS domain.
State Mo En
Complete M Y
Links-Up T Y
Mode: Master
3:8 Port status: Up
Port status: Blocked
sec
3 sec
VID
1000
command.
show eaps
show eaps
Pri Sec Control-Vlan VID
3:8 3:16 c1
3:8 3:16 c2
show eaps <eapsDomain>
Running: Yes
Tag status: Tagged
Tag status: Tagged
ExtremeWare XOS 11.5 Command Reference Guide
:
Count
(1000) 100
(1001) 100
:
9 09:09:35 2004