Show Elrp - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

show elrp

show elrp
Description
Displays ELRP information.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
If you enter the
show elrp
State of ELRP (enabled/disabled).
●
Total number of ELRP sessions.
●
ELRP packets transmitted.
●
ELRP packets received.
●
In addition to the summary information at the top of the display, the
displays the following information:
Client Displays the name of the ELRP client.
VLAN Displays the name of the VLAN with ELRP enabled.
Ports Displays the set of VLAN ports used for packet transmission.
Interval Displays the configured interval. An interval of 3 indicates that ELRP PDUs are transmitted
every 3 seconds.
Count Lists the configured number of ELRP PDUs that are transmitted. The PDUs are transmitted at
the configured interval. This method of ELRP PDU transmission is used by ESRP in the pre-
master state. A count of 0 indicates continuous PDU transmission. If the Cyclic value is Yes,
the count is always 0.
Cyclic Indicates whether ELRP PDUs are being continuously sent. The column shows Yes for the
master VLAN because that VLAN is continuously sending ELRP PDUs for loop detection. When
a VLAN is in the pre-master state, it only sends three ELRP PDUs before changing to master
or slave. During this time the column shows No for that VLAN.
Pkts-Xmit Displays the number of ELRP PDUs transmitted.
Pkts-Rcvd Displays the number of ELRP PDUs received.
ExtremeWare XOS 11.5 Command Reference Guide
command, this command displays the:
command also
show elrp
show elrp
1981