Enable Eaps - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
EAPS Commands

enable eaps

enable eaps {<name>}
Description
Enables the EAPS function for a named domain or for an entire switch.
Syntax Description
name Specifies the name of an EAPS domain.
Default
Disabled.
Default command enables EAPS for the entire switch.
Usage Guidelines
NOTE
If you use the same name across categories (for example, STPD and EAPS names), you must specify the identifying
keyword as well as the actual name.
To configure and enable an EAPS, complete the following steps:
1 Create EAPS domain and assign the name.
2 Configure the control VLAN.
3 Configure the protected VLAN(s).
4 Add the control VLAN to EAPS domain.
5 Add the protected VLAN(s) to EAPS domain.
6 Configure EAPS mode, master or transit.
7 Configure EAPS port, secondary and primary.
8 If desired, configure timeout and action for failtimer expiration*.
9 If desired, configure the hello time for the health-check packets*.
10 Enable EAPS for the entire switch.
11 If desired, enable Fast Convergence*.
12 Enable EAPS for the specified domain.
Although you can enable EAPS prior to configuring these steps, the EAPS domain(s) will not run until
you configure these parameters. (The steps with * can be configured at any time, even after the EAPS
domains are running.)
You must enable EAPS globally and specifically for each named EAPS domain.
1146
ExtremeWare XOS 11.5 Command Reference Guide