Extreme Networks ExtremeWare XOS Command Reference Manual page 1217

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
The following example enables autobind on an STPD named s8 after creating a carrier VLAN named v5:
create vlan v5
configure vlan v5 tag 100
configure vlan v5 add ports 1:1-1:20 tagged
create stpd s8
enable stpd s8 auto-bind v5
configure stpd s8 tag 100
enable stpd s8
To automatically add ports to the CIST STPD and to expand the boundary of the STPD, you must
complete the following tasks:
Create a VLAN or use the Default VLAN. (In this example, the Default VLAN is used.)
●
Create the MSTP region.
●
Create the STPD to be used as the CIST, and configure the mode of operation for the STPD.
●
Specify the priority for the CIST.
●
Assign the VLAN Default to the CIST.
●
Configure the port link type.
●
Enable the CIST.
●
The following example enables autobind on the VLAN Default for the CIST STPD named s1:
configure mstp region 1
create stpd s1
configure stpd s1 mode mstp cist
configure stpd s1 priority 32768
enable stpd s1 auto-bind vlan Default
configure stpd s0 ports link-type point-to-point 2-4
enable stpd s1
The following example enables autobind on the VLAN math for the MSTI STPD named s2:
create vlan math
configure vlan math tag 2
configure vlan math add ports 2-3
configure mstp region 1
create stpd s2
configure stpd s2 mode mstp msti 1
configure stpd s2 priority 32768
enable stpd s2 auto-bind vlan math
configure stpd s2 ports link-type point-to-point 5-6
enable stpd s2
History
This command was available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
ExtremeWare XOS 11.5 Command Reference Guide
enable stpd auto-bind
1217