Configure Mld - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
IPv6 Multicast Commands

configure mld

configure mld <query_interval> <query_response_interval>
<last_member_query_interval> {<robustness>}
Description
Configures the Multicast Listener Discovery (MLD) timers.
Syntax Description
query_interval
query_response_interval
last_member_query_interval
robustness
Default
query interval—125 seconds
●
query response interval—10 seconds
●
last member query interval—1 second
●
robustness—2
●
Usage Guidelines
Timers are based on RFC2710. Specify the following:
query interval—The amount of time, in seconds, the system waits between sending out general
●
queries. The range is 1 to 429,496,729 seconds.
query response interval—The maximum response time inserted into the periodic general queries.
●
The range is 1 to 25 seconds.
last member query interval—The maximum response time inserted into a group-specific query sent
●
in response to a leave group message. The range is 1 to 25 seconds.
robustness—The degree of robustness of the network. The range is 2 to 7.
●
Example
The following command configures the MLD timers:
configure mld 100 5 1 3
History
This command was first available in ExtremeWare XOS 11.2.
1866
Specifies the interval (in seconds) between general queries.
Specifies the maximum query response time (in seconds).
Specifies the maximum group-specific query response time (in seconds).
Specifies the degree of robustness for the network.
ExtremeWare XOS 11.5 Command Reference Guide