Configure Iparp Timeout - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
IP Unicast Commands

configure iparp timeout

configure iparp timeout {vr <vr_name>} <minutes>
Description
Configures the IP ARP timeout period.
Syntax Description
vr_name
minutes
Default
20 minutes.
Usage Guidelines
The range is 0-32,767. A setting of 0 disables timeout.
When the switch learns an ARP entry, it begins the timeout for that entry. When the timer reaches 0, the
entry will be aged out, unless IP ARP refresh is enabled. If ARP refresh is enabled, the switch will ARP
for the address before the timer has expired. If the switch receives a response, it will reset the timer for
that address.
Example
The following command sets the IP ARP timeout period to 10 minutes:
configure iparp timeout 10
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
1338
Specifies which virtual router IP ARP setting to change.
Specifies a time in minutes.
ExtremeWare XOS 11.5 Command Reference Guide