Unconfigure Eaps Port - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

unconfigure eaps port

unconfigure eaps <eapsDomain> [primary | secondary] port
Description
Sets the specified port's internal configuration state to INVALID.
Syntax Description
eapsDomain
primary
secondary
Default
N/A.
Usage Guidelines
Unconfiguring an EAPS port sets its internal configuration state to INVALID, which causes the port to
appear in the Idle state with a port status of Unknown when you use the
to display the status information about the port.
To prevent loops in the network, the switch displays by default a warning message and prompts you to
unconfigure the specified EAPS primary or secondary ring port. When prompted, do one of the
following:
Enter to unconfigure the specified port.
●
y
Enter or press [Return] to cancel this action.
●
n
If you have considerable knowledge and experience with EAPS, you might find the EAPS loop
protection warning messages unnecessary. For more information, see the
command
warnings off
Example
The following command unconfigures this node's EAPS primary ring port on the domain eaps_1:
unconfigure eaps eaps_1 primary port
The switch displays the following warning message and prompts you to confirm this action:
WARNING: Unconfiguring the Primary port from the EAPS domain could cause a loop in
the network!
Are you sure you want to unconfigure the Primary EAPS Port? (y/n)
Enter to continue and unconfigure the EAPS primary ring port. Enter
y
The switch displays a similar warning message if you unconfigure the secondary EAPS port.
ExtremeWare XOS 11.5 Command Reference Guide
Specifies the name of an EAPS domain.
Specifies that the primary port should be unconfigured.
Specifies that the secondary port should be unconfigured.
on page 1117.
unconfigure eaps port
command
show eaps detail
configure eaps config-
to cancel this action.
n
1161