Configure Mvr Add Receiver - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
IP Multicast Commands

configure mvr add receiver

configure mvr vlan <vlan-name> add receiver port <port-list>
Description
Configures a port to receive MVR multicast streams.
Syntax Description
vlan-name
port-list
Default
N/A.
Usage Guidelines
This command is used to add a group of virtual ports for multicast forwarding through MVR. By
default, some ports on non-MVR VLANs (router ports, primary and secondary EAPS ports), are
excluded from the MVR cache egress list. This command is used to override these rules, so that if valid
IGMP memberships are received, or a router is detected, streams would be forwarded out on the ports.
Example
The following command adds the ports 1:1 and 1:2 of VLAN v1 to MVR for forwarding:
configure mvr vlan v1 add receiver port 1:1-1:2
History
This command was first available in ExtremeWare XOS 11.4.
Platform Availability
This command is available on all platforms.
1804
Specifies a VLAN name.
A list of ports or slots and ports.
ExtremeWare XOS 11.5 Command Reference Guide