Extreme Networks ExtremeWare XOS Command Reference Manual page 1147

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
enable eaps
BlackDiamond 8800 Series Switch and Summit X450 Family of Switches Only. If you configure EAPS
spatial reuse and disable the EAPS domain on a transit node, this may cause EAPS PDUs from being
forwarded through out the domain thereby causing the master node's fail timer to expire. If this occurs,
make sure the EAPS domain is enabled on all of the transit nodes. To confirm the current state of EAPS
on the switch, use the command.
show eaps
Example
The following command enables the EAPS function for entire switch:
enable eaps
The following command enables the EAPS function for the domain "eaps-1":
enable eaps eaps-1
History
This command was first available in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms.
1147
ExtremeWare XOS 11.5 Command Reference Guide