Extreme Networks ExtremeWare XOS Command Reference Manual page 1914

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Configuration and Image Commands
The PSU controller firmware is used immediately after it is installed without rebooting the switch. The
new BootROM and firmware overwrite the older versions flashed into the hardware. Use the
reboot
command to reboot the switch and activate the new BootROM and firmware.
During the firmware upgrade, do not cycle down or disrupt the power to the switch. If a power
interruption occurs, the firmware may be corrupted and need to be recovered. ExtremeWare XOS
automatically recovers corrupted firmware; however, the time it takes for the switch to boot-up may
increase.
The switch displays status messages after you use the command. The output varies
install firmware
depending upon your platform and the software version running on your system.
NOTE
If the information in the most current version of the ExtremeWare XOS Installation and Release Notes differs from
the information in this section, follow the release notes.
Sample Output—BlackDiamond 8800 Series Switch. The following is sample output from the
BlackDiamond 8800 series switch:
Installing version 1.0.1.7 of the MSM bootrom(s). Do you want to continue?
(y - yes, n - no, <cr> - cancel) Yes
Do you want to save configuration changes to primary.cfg? (y or n) Yes
Saving configuration on primary MSM ....... done!
Installing version 1.0.1.7 of the IO module bootrom(s). Do you want to continue?
(y - yes, n - no, <cr> - cancel) Yes
Installing version 2.11 of the PSU control module firmware. Do you want to continue?
(y - yes, n - no, <cr> - cancel) Yes
Installing bootrom...
MSM bootrom(s) installed successfully
MSM bootrom(s) will be activated upon next MSM reboot
Installing bootrom...
IO module bootrom(s) installed successfully
IO module bootrom(s) will be activated upon next IO module reboot
Installing firmware...
PSU controller firmware installed successfully
Sample Output—BlackDiamond 12804 Switch. The following is sample output from the BlackDiamond
12804 switch:
Installing version 1.0.0.2 of the MSM bootrom(s). Do you want to continue?
(y - yes, n - no, <cr> - cancel) Yes
Installing IO module firmware, a reboot is required. Do you want to continue?
(y - yes, n - no, <cr> - cancel) Yes
Installing version 2.13 of the PSU control module firmware. Do you want to continue?
(y - yes, n - no, <cr> - cancel) Yes
Installing micro controller image on backup MSM requires rebooting backup MSM. Do you
want to continue?
(y - yes, n - no, <cr> - cancel) Yes
Installing bootrom...
Installing bootstrap
1914
ExtremeWare XOS 11.5 Command Reference Guide