Unconfigure Switch - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Configuration and Image Commands

unconfigure switch

unconfigure switch {all}
Description
Returns the switch configuration to its factory default settings and reboots the switch.
Syntax Description
all
Default
N/A.
Usage Guidelines
Use
unconfigure switch
configuration. This preserves users account information, date and time settings, and so on.
Include the parameter
reboot using the last used image and factory default configuration.
The command
disabled once it is enabled on the switch.
Example
The following command preserves the entire current configuration (but does not reload the current
configuration after the switch reboots), resets the switch to factory defaults, and reboots the switch
using the last specified saved image and factory default configuration:
unconfigure switch all
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
1934
Specifies that the entire current configuration should be erased, including the
management IP address, and the switch rebooted.
to reset the configuration to factory defaults, but without erasing the
to clear the entire current configuration, including all switch parameters, and
all
unconfigure switch {all}
does not clear licensing information. The license cannot be
ExtremeWare XOS 11.5 Command Reference Guide