Extreme Networks ExtremeWare XOS Command Reference Manual page 1925

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
If you enter , the switch saves the configuration and displays a series of messages. The following
y
sections provide information about the messages displayed when you save a configuration on your
switch.
Local Filename Character Restrictions. This section provides information about the characters supported
by the switch for local filenames.
When specifying a local filename, the switch permits only the following characters:
Alphabetical letters, upper case and lower case (A-Z, a-z)
●
Numerals (0-9)
●
Period ( . )
●
Dash ( - )
●
Underscore ( _ )
●
When naming a local file, remember the requirements listed above.
Saving a New Configuration. If you create and save a configuration with a new file name, the switch
saves the new configuration and then prompts you to select the newly created configuration as the
switch's default configuration.
The following sample output is similar to the message displayed:
Do you want to save configuration to test1.cfg? (y/n) Yes
Saving configuration on primary MSM ................................. done!
Configuration saved to test1.cfg successfully.
The switch then prompts you to select which configuration to use to bootup the system. The following
sample output is similar to the message displayed:
The current selected default configuration database to boot up the system
(primary.cfg) is different than the one just saved (test.cfg).
Do you want to make test.cfg the default database? (y/n)
Enter to use the new configuration as the default configuration. Enter
y
keep using the current default, active configuration.
Saving an Existing Configuration. If you make and save changes to an existing configuration, the switch
prompts you to save and override the existing configuration.
The following sample output is similar to the message displayed:
The configuration file test.cfg already exists.
Do you want to save configuration to test.cfg and overwrite it? (y/n) Yes
Saving configuration on primary MSM ............................... done!
Configuration saved to test.cfg successfully.
If you override an existing configuration that is not the current default, active configuration, the switch
prompts you to select which configuration to use to bootup the system. The following sample output is
similar to the message displayed:
The current selected default configuration database to boot up the system
(primary.cfg) is different than the one just saved (test.cfg).
Do you want to make test.cfg the default database? (y/n) No
Default configuration database selection cancelled.
ExtremeWare XOS 11.5 Command Reference Guide
save configuration
to cancel the operation and
n
1925