Configure Eaps Add Protected Vlan - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

configure eaps add protected vlan

configure eaps <name> add protected vlan <vlan_name>
Description
Adds the specified protected VLAN to the specified EAPS domain.
Syntax Description
name
vlan_name
Default
N/A.
Usage Guidelines
You must configure one or more protected VLANs for each EAPS domain. The protected VLANs are the
data-carrying VLANs.
A protected VLAN can be added to one or more EAPS domains.
When you configure the VLAN that will act as a protected VLAN, the ring ports of the protected VLAN
must be tagged (except in the case of the default VLAN). As long as the ring is complete, the master
node blocks the protected VLANs on its secondary port.
NOTE
If the protected VLAN has a QoS profile of QP8, make sure the control VLAN has the appropriate QoS profile
setting. For more information, see the command
The VLAN must already exist before you can add it as a protected VLAN. If you attempt to add a
VLAN that does not exist, the switch displays a message similar to the following:
* Switch.5 # configure eaps megtest add protected foo
%% Invalid input detected at '^' marker.
To create the VLAN, use the
Example
The following command adds the protected VLAN "orchid" to the EAPS domain "eaps_1":
configure eaps eaps_1 add protected vlan orchid
ExtremeWare XOS 11.5 Command Reference Guide
Specifies the name of an EAPS domain.
Specifies the name of the protected VLAN.
configure eaps add control vlan on page
command.
create vlan
configure eaps add protected vlan
^
1113.
1115