Extreme Networks ExtremeWare XOS Command Reference Manual page 1908

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Configuration and Image Commands
NOTE
ExtremeWare XOS 11.5 introduces support for the BlackDiamond 8800 a-series and e-series modules. If your switch
is running ExtremeWare XOS 11.4 or earlier, you must upgrade to ExtremeWare XOS 11.5 to operate the modules.
Hitless upgrade is not supported between major releases. Do not attempt to perform a hitless upgrade. To upgrade
the switch from ExtremeWare XOS 11.4 or earlier to ExtremeWare XOS 11.5, reboot the switch after downloading
and installing the 11.5 image to both installed MSMs.
Example
The following command downloads the switch software image from the TFTP server at 10.10.15.04,
from the file named bd10K-11.0.0.25.xos:
download image 10.10.15.04 bd10K-11.0.0.25.xos
Although the example command specifies a BlackDiamond 10808 image, the output is similar on all
modular switches. On a modular switch, if you download an image into the active partition, you see
output similar to the following:
Do you want to install image after downloading? (y - yes, n - no, <cr> - cancel) Yes
Downloading to
MSM-A..............................................................
Downloading to MSM-B..................................
Image will be installed to the active partition, a reboot required. Do
you want to continue? (y/n) Yes
Installing to primary partition!
Installing to
MSM-
B..............................................................................
...............................................................................
...............................................................................
...............................................................................
.....................................
Installing to
MSM-
A..............................................................................
...............................................................................
...............................................................................
............................
If you answer to installing the image, the switch reboots upon completion of the installation.
yes
The following command downloads the switch software image from the TFTP server at 10.10.15.04,
from the file named summitX450-11.2.0.15.xos:
download image 10.10.15.04 summitX450-11.2.0.15.xos
If you download an image into the active partition, you see output similar to the following:
Do you want to install image after downloading? (y - yes, n - no, <cr> - cancel) Yes
1908
ExtremeWare XOS 11.5 Command Reference Guide