Extreme Networks ExtremeWare XOS Command Reference Manual page 1916

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Configuration and Image Commands
NOTE
When you use the
modules enter the Down state. Upgrade the firmware when you can schedule a downtime for your network.
NOTE
Upgrading the firmware on a BlackDiamond 12804 switch can take a minimum of 6 minutes per slot.
For single MSM systems, reboot the switch using the
complete.
For dual MSM systems, the
while the MSM is primary. To completely install the firmware, an MSM failover is required. To do this,
complete the following:
1 On the primary MSM, use the
firmware images.
2 When the installation is complete, initiate failover to the backup MSM using the
command.
3 On the new primary MSM, use the
images.
4 When the installation is complete, return to your original primary MSM by initiating failover from
the new backup MSM to the original primary MSM using the
NOTE
Because two failovers are required for a dual-MSM firmware installation, you do not use the
after executing the firmware installation.
Displaying BootROM and Firmware Versions. To display the BootROM (firmware) version for all modules
and PSU controllers installed in the switch, use the
Recovering From a Corrupted BootROM—BlackDiamond 8800 Series Switch Only. If your default BootROM
image becomes corrupted, you can force the MSM to boot from an alternate BootROM image by
inserting a pen into the Alternate (A) and Reset (R) holes on the BlackDiamond 8800 MSM and
applying pressure. For more information, please refer to the Extreme Networks Consolidated XOS
Hardware Installation Guide.
Example
The following command installs the newer firmware image(s):
install firmware
History
This command was first available in ExtremeWare XOS 11.1.
1916
command to install the new BootROM and firmware images, all of the I/O
install firmware
install firmware
install firmware
install firmware
command after the firmware installation is
reboot
command cannot install all of the necessary software
command to install the new BootROM and/or
command to install the remaining firmware
run msm-failover
command.
show version
ExtremeWare XOS 11.5 Command Reference Guide
run msm-failover
command.
command
reboot