Extreme Networks ExtremeWare XOS Command Reference Manual page 1920

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Configuration and Image Commands
downloaded and installed on the switch, use the command to initiate failover from
run msm-failover
the primary MSM to the backup MSM. The original primary MSM becomes the new backup MSM.
After failover is complete, download the software to the new backup MSM. Again, if you download the
image to the inactive partition, use the
install image <fname> {<partition>} {msm <slotid>}
command to install the software image at a later time.
{reboot}
For more detailed information about hitless upgrade, see the command.
download image
Example
The following command installs the software image file bd12K-11.4.0.26.xos on a BlackDiamond 12804
switch:
install image bd12K-11.4.0.26.xos
The following command installs the software image file bd10K-11.1.0.20.xos on a BlackDiamond 10808
switch:
install image bd10K-11.1.0.20.xos
The following command installs the software image file bd8800-11.3.0.10.xos on a BlackDiamond 8810
switch:
install image bd8800-11.3.0.10.xos
The following command installs the software image file summitX450-11.5.1.2.xos on a Summit X450
family switch:
install image summitX450-11.5.1.2.xos
History
This command was first available in ExtremeWare XOS 10.1.
The parameter was added in ExtremeWare XOS 11.1.
msm
Platform Availability
This command is available on all platforms.
1920
ExtremeWare XOS 11.5 Command Reference Guide