Run Elrp - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Troubleshooting Commands

run elrp

run elrp <vlan_name> {ports <ports>} {interval <sec>} {retry <count>}
Description
Starts one-time, non-periodic ELRP packet transmission on the specified ports of the VLAN using the
specified count and interval.
Syntax Description
vlan_name
ports
sec
count
Default
—The interval between consecutive packet transmissions is 1 second.
●
sec
—The number of time ELRP packets must be transmitted is 10.
●
count
Usage Guidelines
This command starts one-time, non-periodic ELRP packet transmission on the specified ports of the
VLAN using the specified count and interval. If any of these transmitted packets is returned, indicating
loopback detection, the ELRP client prints a log message to the console. There is no need to send a trap
to the SNMP manager for non-periodic requests.
NOTE
This command is compatible with Extreme Networks switches running only the ExtremeWare XOS software. If your
network contains switches running ExtremeWare XOS and switches running ExtremeWare, use the
elrp-client one-shot <vlan_name> ports [<ports> | all] interval <sec> retry <count>
[log | print | print-and-log]
If you do not specify the optional
Use the
configure elrp-client periodic
packets.
The ELRP client must be enabled globally in order for it to work on any VLANs. Use the
enable elrp-client
The ELRP client can be disabled globally so that none of the ELRP VLAN configurations take effect. Use
the
disable elrp-client
1972
Specifies a VLAN name.
Specifies the set of VLAN ports for packet transmission.
Specifies the interval (in seconds) between consecutive packet transmissions.
The range is 1 to 64 seconds. The default is 1 second.
Specifies the number of times ELRP packets must be transmitted. The range is
3 to 255 times. The default is 10 times.
command to perform one-time ELRP packet transmission.
or
interval retry
command to configure periodic transmission of ELRP
command to globally enable the ELRP client.
command to globally disable the ELRP client.
parameters, the default values are used.
ExtremeWare XOS 11.5 Command Reference Guide
configure