Configure Eaps Failtime Expiry-Action - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

configure eaps failtime expiry-action

configure eaps <name> failtime expiry-action [open-secondary-port | send-
alert]
Description
Configures the action taken when the failtimer expires.
Syntax Description
name
open-secondary-port
send-alert
Default
Default is send-alert.
Usage Guidelines
By default the action is to send an alert if the failtimer expires. Instead of going into a "Failed" state, the
master node remains in a "Complete" or "Init" state, maintains the secondary port blocking, and writes
a critical error message to syslog warning the user that there is a fault in the ring. An SNMP trap is also
sent.
If the EAPS ring contains non-EAPS devices, you must use the
NOTE
Use caution when setting the failtimer expiry action to open-secondary port. Using this configuration, if the
master node loses three consecutive hello PDUs, the failtimer will expire—but there may not be a break in the ring.
Opening the secondary port in this situation would create a loop.
Example
The following command configures the failtimer expiry action for EAPS domain "eaps_1":
configure eaps eaps_1 failtime expiry-action open-secondary-port
History
This command was first available in ExtremeWare XOS 11.0.
ExtremeWare XOS 11.5 Command Reference Guide
Specifies the name of an EAPS domain.
Specifies to open the secondary port when the failtimer expires.
Specifies that a critical message is sent to the syslog when the failtimer
expires.
configure eaps failtime expiry-action
parameter.
open-secondary-port
1125