Extreme Networks ExtremeWare XOS Command Reference Manual page 1895

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
configure firmware
If you download a new image and new firmware images are available, you see messages similar to the
following:
download image bd8800-11.3.0.10.xos
Do you want to install image after downloading? (y - yes, n - no, <cr> - cancel) Yes
Downloading to MSM-
A.....................................................................................
.............
Image will be installed to the active partition, a reboot required. Do you want to
continue? (y/n) Yes
Do you want to save configuration changes to primary.cfg? (y or n) Yes
Saving configuration on primary MSM ............. done!
Installing to primary partition!
Installing to MSM-
A.....................................................................................
......................................................................................
......................................................................................
......................................................................................
......................................................................................
.......................................................................
Image installed successfully
Installing version 1.0.0.16 of the MSM bootrom(s). Do you want to continue? (y/n)
Yes
Installing version 1.0.0.24 of the IO module bootrom(s). Do you want to continue?
(y/n) Yes
Installing version 2.4 of the PSU control module firmware. Do you want to continue?
(y/n) Yes
Installing bootrom...
MSM bootrom(s) installed successfully
Installing bootrom...
IO module bootrom(s) installed successfully
Installing firmware...
PSU controller firmware installed successfully
...
Displaying BootROM and Firmware Versions. To display the BootROM (firmware) version for all modules
and PSU controllers installed in the switch, use the command.
show version
Recovering From a Corrupted BootROM. If your default BootROM image becomes corrupted, you can force
the MSM to boot from an alternate BootROM image by inserting a pen into the Alternate (A) and Reset
1895
ExtremeWare XOS 11.5 Command Reference Guide