Synchronize - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

synchronize

synchronize
Description
Replicates all saved images and configurations from the primary MSM to the backup MSM on the
switch.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
This command:
1 Reboots the backup MSM to prepare it for synchronizing with the primary MSM
2 Performs a binary copy of the primary MSM to the backup MSM, including the primary and
secondary software images, all configurations and policies, and temporary files
3 Reboots the backup MSM after replication is complete
During a synchronization, half of the switch fabric is lost. When the primary MSM finishes replicating
its configurations and images to the backup MSM, the full switch fabric is restored.
To use the
synchronize
BlackDiamond 10808 switch—Both the backup and the primary MSMs must be running
●
ExtremeWare XOS 11.0 or later.
BlackDiamond 8810 switch with 8800 original modules installed—Both the backup and the primary
●
MSMs must be running ExtremeWare XOS 11.1 or later.
BlackDiamond 8806 switch with 8800 original modules installed—Both the backup and the primary
●
MSMs must be running ExtremeWare XOS 11.3 or later.
BlackDiamond 8800 series switch with 8800 a- and e-series modules installed—Both the backup and
●
the primary MSMs must be running ExtremeWare XOS 11.5 or later.
BlackDiamond 12804 switch—Both the backup and the primary MSMs must be running
●
ExtremeWare XOS 11.4 or later.
When you install a backup MSM, you are not prompted to synchronize the images and the
configurations from the primary. If not synchronized, the backup uses its image and the primary's
configuration. This image/configuration mismatch will likely cause the switch to operate differently
after failover. Use the
synchronize
primary to the backup.
If you have not saved your runtime configuration, you are prompted to save it when you use the
command. A message similar to the following appears:
synchronize
ExtremeWare XOS 11.5 Command Reference Guide
command make sure your switch is running the following software:
command to replicate all saved images and configurations from the
synchronize
1931