Configure Cna-Testplug Vlan - Extreme Networks ExtremeWare XOS Command Reference Manual

Software version 11.5

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

configure cna-testplug vlan

configure cna-testplug vlan <vlan_name>

Configures the CNA Agent (test plug) to an interface. By default, the CNA Agent is bound to the

Default VLAN.

Default VLAN.

Usage Guidelines

The interface IP address is specified when setting up the SSL connection with the CNA Server (when

you issue the

configure cna-testplug scheduler ipaddress

to establish the socket connection on the interface specified in the

interface to conduct the actual tests.

The system uses the primary IP address if the VLAN has more than one IP address. By default, the

CNA Server uses the Default VLAN.

Extreme Networks recommends that you put IP telephones on the same virtual router.

The following command instructs the CNA Server to use the interface associated with VLAN gateway

to conduct tests:

configure cna-testplug vlan gateway

This command was first available in ExtremeWare XOS 11.2.

Platform Availability

This command is available on all platforms.

ExtremeWare XOS 11.5 Command Reference Guide

Specifies which interface IP address the CNA Server uses to communicate with

the CNA Agent.

configure cna-testplug vlan

command. The CNA Server attempts

configure cna-testplug vlan

Extremeware xos 11.5