Extreme Networks ExtremeWare XOS Command Reference Manual page 1132

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
EAPS Commands
The following command identifies this switch as a transit node for the domain named eaps_1:
configure eaps eaps_1 mode transit
The switch displays the following warning message and prompts you to confirm this action:
WARNING: Make sure this specific EAPS domain has a Master node in the ring. If
you change this node from EAPS master to EAPS transit, you could cause a
loop in the network.
Are you sure you want to change mode to transit? (y/n)
Enter to identify the switch as a transit node. Enter n to cancel this action.
y
History
This command was first available in ExtremeWare XOS 11.0.
The interactive messages were added in ExtremeWare XOS 11.4.
Platform Availability
This command is available on all platforms.
1132
ExtremeWare XOS 11.5 Command Reference Guide