ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
configure eaps port
Enter
to add the ports to the VLAN. Enter
or press [Return] to cancel this action.
y
n
If you see this message, either configure the VLAN as an EAPS protected VLAN by using the
command or add ports that the EAPS domain does not use as
configure eaps add protected vlan
primary or secondary ring ports.
If you have considerable knowledge and experience with EAPS, you might find the EAPS loop
protection warning messages unnecessary. For more information, see the
configure eaps config-
command
on page
1117.
warnings off
Example
The following command adds port 1 of the module installed in slot 8 to the EAPS domain "eaps_1" as
the primary port:
configure eaps eaps_1 primary port 8:1
History
This command was first available in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms.
1135
ExtremeWare XOS 11.5 Command Reference Guide