Create Stpd - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

create stpd

create stpd <stpd_name>
Description
Creates a user-defined STPD.
Syntax Description
stpd_name
Default
The default device configuration contains a single STPD called s0.
When an STPD is created, the STPD has the following default parameters:
State—disabled
●
StpdID—none
●
Assigned VLANs—none
●
Bridge priority—32,768
●
Maximum BPDU age—20 seconds
●
Hello time—2 seconds
●
Forward delay—15 seconds
●
Operational mode—802.1D
●
Rapid Root Failover—disabled
●
Default Binding Mode (encapsulation mode)—Ports in the default STPD (s0) are in
●
Ports in user-created STPDs are in
Maximum hop count (when configured for MSTP)—20 hops
●
Usage Guidelines
The maximum length for a name is 32 characters. Names can contain alphanumeric characters and
underscores ( _ ) but cannot be any reserved keywords, for example, stp or stpd. Names must start with
an alphabetical character, for example, a, Z.
Each STPD name must be unique and cannot duplicate any other named STPDs on the switch. If you
are uncertain about the STPD names on the switch, use the
names.
ExtremeWare XOS 11.5 Command Reference Guide
Specifies a user-defined STPD name to be created. May be up to 32
characters in length.
mode.
emistp
command to view the STPD
show stpd
create stpd
mode.
802.1d
1207