Configure Mvr Mvr-Address - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
IP Multicast Commands

configure mvr mvr-address

configure mvr vlan <vlan-name> mvr-address {<policy-name> | none}
Description
Configures the MVR address range on a VLAN.
Syntax Description
vlan-name
policy-name
Default
The default address range is 224.0.0.0/4 (all multicast addresses), but excluding 224.0.0.0/24 (the
multicast control range).
Usage Guidelines
If no policy file is specified (the
the multicast control range 224.0.0.0/24 is used for MVR.
MVR must first be configured on the VLAN before using this command.
If the policy is later refreshed, groups denied and newly allowed groups in the policy will be flushed
from fast path forwarding. This will allow synching existing channels with the new policy, without
disturbing existing channels.
The following is a sample policy file mvrpol.pol. This policy configures 236.1.1.0/24 as the MVR
address range. Any address outside this range will have the standard switching behavior on an MVR
VLAN.
Entry extreme1 {
if match any {
nlri
}
then {
permit ;
}
}
Example
The following command configures the MVR address range specified in the policy file mvrpol.pol for
the VLAN v1:
configure mvr vlan v1 mvr-address mvrpol
1808
Specifies a VLAN name.
Specifies a policy file.
option), the entire multicast address range 224.0.0.0/4, except for
none
236.1.1.0/24 ;
ExtremeWare XOS 11.5 Command Reference Guide