Configure Debug Core-Dumps - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

configure debug core-dumps

configure debug core-dumps [internal-memory | memorycard | off]
Description
Enables or disables sending debug information to the specified memory card.
Syntax Description
internal-memory
memorycard
off
Default
By default, the switch does not automatically send debug information to the memory card. The setting
is set to .
off
Usage Guidelines
NOTE
Use this command only under the guidance of Extreme Networks Technical Support personnel to troubleshoot the
switch.
The switch sends debug information to the preinstalled internal memory card. On modular switches,
you can also send debug information to the external memory card installed in the external compact
flash slot of the MSM.
The switch only generates core dump files and writes them to the specified memory card in the
following situations:
If an ExtremeWare XOS process fails.
●
When forced under the guidance of Extreme Networks Technical Support.
●
If you configure the switch to write core dump files to the internal memory and attempt to download a
new software image, you might have insufficient space to complete the image download. If this occurs,
move or delete the core dump files from the internal memory. For example, if you have a modular
switch with an external memory card installed with space available, transfer the files to the external
ExtremeWare XOS 11.5 Command Reference Guide
Specifies that saving debug information to the internal memory card is
enabled.
Use this parameter only under the guidance of Extreme Networks Technical
Support personnel.
Specifies that saving debug information to the external memory card is
enabled.
Use this parameter only under the guidance of Extreme Networks Technical
Support personnel.
NOTE: This parameter is available only on modular switches.
Specifies that saving debug information to the memory card is disabled. This is
the default behavior.
configure debug core-dumps
1951