Configure Netlogin Dot1X Timers - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Network Login Commands

configure netlogin dot1x timers

configure netlogin dot1x timers [{server-timeout <server_timeout>} {quiet-
period <quiet_period>} {reauth-period <reauth_period>} {supp-resp-timeout
<supp_resp_timeout>}]
Description
Configures the 802.1x timers for Network Login.
Syntax Description
server-timeout
quiet-period
reauth-period
supp-resp-timeout
Default
The defaults are as follows:
server-timeout—30 seconds.
●
quiet-period—60 seconds.
●
reauth-period—3600 seconds.
●
supp-resp-timeout—30 seconds.
●
Usage Guidelines
To disable re-authentication, specify 0 for the
If you attempt to configure a timer value that is out of range (not supported), the switch displays an
error message. The following is a list of sample error messages:
●
server-timeout
●
quiet-period
●
reauth-period
●
supp-resp-timeout
To display the 802.1x timer settings, use the
1060
Specifies the timeout period for a response from the RADIUS server. The range
is 1 to 120 seconds.
Specifies the time for which the switch will not attempt to communicate with
the supplicant after authentication has failed. The range is 0 to 65535
seconds.
Specifies time after which the switch will attempt to re-authenticate an
authenticated supplicant. The range is 0, 30 to 7200 seconds.
Specifies the time for which the switch will wait for a response from the
supplicant. The range is 1 to 120 seconds.
—
ERROR: RADIUS server response timeout out of range (1..120 sec)
—
%% Invalid number detected at '^' marker.
%% Input number must be in the range [0, 65535].
—
ERROR: Re-authentication period out of range (0, 30..7200 sec)
—
ERROR: Supplicant response timeout out of range (1..120 sec)
parameter.
reauth-period
and
show netlogin show netlogin
ExtremeWare XOS 11.5 Command Reference Guide
commands.
dot1x