Table of Contents
Advertisement
CLI Commands
add
add (router-lan) filter
Use the add (router-lan) filter commands to add filters to the specified LAN interface.
add (router-lan) filter address
Use the add (router-lan) filter address command to add an address filter to the table of
Layer 2 filters applied to the specified LAN interface.
Syntax:
Example:
{rtr_lan-addr}
The Router (IP or CMG) address is in the form {slot:port} or {slot "profile-name"}.
slot
port
"profile-name"
{both|dest|source}
both
dest
source
{mac-addr}
The MAC address to add to the learned address table for the LAN, in the form a
6-octet HEX value, 0xxxxxxxxxxxx. Please note that the MAC address is preceeded by a
0x.
{"filter-name"}
A symbolic name given to identify a filter rule. This name must be enclosed in quotes, with
a maximum of 8 characters.
5-12
add {rtr_lan-addr} filter address {both|dest|source}
{mac-addr} {"filter-name"}
add 2:1 filter address both 0x00e09700e9cd "Server1"
The slot number (1-6) that contains the Router card.
Port number.
The profile name for the Router interface. Name must be enclosed
in quotes, with a maximum length of 11 characters.
Filter by both source and destination
Filter by destination only
Filter by source only
Compact T1 - Release 6.1
Advertisement
Table of Contents
