Table of Contents
Advertisement
CLI Commands
set
set (router-voice) down
Use the set (router-voice) down command to take a CMG voice channel out-of-service. Once
out-of-service, the call agent cannot access the endpoint ID associated with this voice channel.
Also, the phone, fax, or data user connected to this channel from an FXS port or T12 channel
cannot make or receive calls. The options for this command allow the invoker of the command
to specify how the call agent is to treat the voice channel as it goes out-of-service. The default
option ("now") causes an immediate termination of any active call, with an RSIP with "forced"
restart method sent to the call agent. Use of the "graceful" or "timeout" option provides for
keeping an active call up, either for its duration or for a particular timeout period, before the
channel is taken out-of-service. In this case, an RSIP with "graceful" restart method is sent
initially to the call agent. After the call is disconnected or the timeout period expires, the
channel is taken out-of service, and a final RSIP is sent with the "forced" restart method.
Syntax:
Example:
{cmg_voice-addr}
In the form {slot:voip:port}
slot
voip
channel
{graceful|now|timeout}
graceful
now
timeout
[seconds]
When timeout is selected, this field defines the number of seconds to wait before taking
endpoints Out-of-Service. Default time is 60 seconds.
5-172
set {cmg_voice-addr} down {graceful|now|timeout}
[seconds]
set 2:1:1:9 down now
The example will take voice channel 9 out-of-service immediately, on the CMG
card in slot 2.
The slot number (1-6) that contains the CMG card.
To designate VoIP 1:1 is used.
Channel number for the router is 1-48, range or all
Wait for current calls to end before placing endpoint Out-of-Service
Disconnect any existing calls immediately (Default)
Wait a defined time (see time below), then disconnect calls
Compact T1 - Release 6.1
Advertisement
Table of Contents
