Table of Contents
Advertisement
set snmp
Use the set snmp command to set the Simple Network Management Protocol (SNMP) MIB-II
System Group objects.
Syntax:
Example:
Example:
{setting}
Set the values for any of the following SNMP MIB-II System Group object
contact {string}
getcom {string}
location {string}
name {string}
nms {n} {ip-addr}
setcom {string}
trapauth
{disable|enable}
trapcom {string}
trapevent {setting}
trapvers {1|2}
Compact T1 - Release 6.1
set snmp {setting} {string}
Where {setting} is as below, and {string} is its value.
set snmp name "ADIT 1"
To set the SNMP system name to "ADIT 1"
set snmp nms 2 192.168.3.50
Set the second SNMP NMS IP address to 192.168.3.50
SysContact. 1 - 255 characters, enclosed in quotes
SNMP Get-Community. 1 - 32 characters, enclosed in quotes
SysLocation. 1 - 255 characters, enclosed in quotes
Set the value of the SysName (name enclosed by quotes).
Set the IP address of the SNMP manager where the SNMP agent
will send traps (up to 3 NMS addresses). The {n} is a number
from 1 to 3, to differentiate your NMS addresses.
Set the value of the SNMP Set-Community string.
Enable or disable authentication traps.
Set the value for the SNMP Trap-Community string. 1 - 32
characters, enclosed in quotes
Set minimum severity level for (enterprise) event trap generation.
all
critical
major
minor
warning
none
Set SNMP trap version number, 1 or 2.
Example: set snmp trapvers 1
Set event trap severity limit to 'all'.
Set event trap severity limit to 'critical'.
Set event trap severity limit to 'major'.
Set event trap severity limit to 'minor'.
Set event trap severity limit to 'warning'.
Set event trap severity limit to 'none'.
CLI Commands
set
5-197
Advertisement
Table of Contents
