Add (Router) Snmp Trap - Black Box Compact T1 MT850A User Manual

add (router) snmp trap

Use the add (router) snmp trap command to specify a destination to send SNMP trap
messages for the specified Router card.
Syntax:
Example:
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{"community-name"}
The community name to use in each trap message, with a maximum of 10 characters.
{ip-addr}
The IP address of the destination trap to add, in the form of xxx.xxx.xxx.xxx, where xxx is
between 0-255.
{"profile-name"}
The profile name for the Router interface that is used to reach this destination. Maximum
of 11 characters and this name must be enclosed in quotes.
Compact T1 - Release 6.1
add {rtr_card-addr} snmp trap
{"community-name"} {ip-addr} {"profile-name"}
add 3 snmp trap "commune" 192.168.100.245 "RemoteAdit"
The example will add a trap destination of 192.168.100.245 on the interface
"RemoteAdit" and use the community name "commune" in the messages. The
Router is located in slot 3.
CLI Commands
add
5-9