Table of Contents
Advertisement
CLI Commands
status
status ipds0
Use the status ipds0 command to display the current status of the DS0 management channel.
Syntax:
Example:
> status ipds0
Operational state:
status (ocudp)
Use the status (ocudp) command to displaystatus for selftest and loopbacks.
Syntax:
Example:
SLOT 2:
Status for OCUDP Port 1:
Results as of 23:25:48
{ocudp-addr}
The {slot:port} address of the OCU-DP card to display.
slot
port
5-262
status ipds0
status ipds0
status {ocudp-addr}
status 2:1
Selftest:
Datapath:
FPGA:
OCU:
OCU Manual Loopback:
CSU Manual Loopback:
OCU NonLatching Loopback:
DSU NonLatching Loopback:
CSU NonLatching Loopback:
OCU Latching Loopback:
DSU Latching Loopback:
CSU Latching Loopback:
Slot number (1-6) where the OCU-DP is located
Port number or range.
DOWN
01/07/2001
PASS
PASS
PASS
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
Compact T1 - Release 6.1
Advertisement
Table of Contents
