Set (Router-Voice) Txgain; Set (Router-Voice) Up - Black Box Compact T1 MT850A User Manual

set (router-voice) txgain

Use the set (router-voice) txgain command to set the gain on the transmit side (TDM-to-
packet) voice path for the specified voice channel(s). This gain setting can be overridden by the
call agent on a call-by-call basis. Note: DTMF detection can be gain sensitive, some adjustment
may be necessary. This command applies to the CMG Router card only.
Syntax:
Example:
{cmg_voice-addr}
In the form {slot:voip:port}
slot
voip
channel Channel number for the router is 1-48, range or all
{gain}
Gain range is -14 to 14 dB. Default is 0 dB.

set (router-voice) up

Use the set (router-voice) up command to bring a voice channel back into service. This will
cause an RSIP message to be sent to the call agent, with the "restart" value for the Restart
Method parameter. It will also enable the processing of TDM-side events (eg: offhook) which
are either requested by the call agent or are defined as persistent events see set (router) mgcp
report hookswitch. Note: The RSIP message is not sent immediately when the "up" command
is given. It is sent after a random delay of not more than about 30 seconds. It is best if calls to
or from the channel are not attempted until about 30 seconds after the "up" command is given.
This command applies to the CMG Router card only.
Syntax:
Example:
{cmg_voice-addr}
In the form {slot:voip:port}
slot
voip
channel
Compact T1 - Release 6.1
set {cmg_voice-addr} txgain {gain}
set 2:1:1:9 txgain 6
The example sets the transmit-side gain to 6 dB for the CMG card in slot 2.
The slot number (1-6) that contains the CMG card.
To designate VoIP 1:1 is used.
set {cmg_voice-addr} up
set 2:1:1:2 up
The example will set channel 2 back in-service on the CMG card in slot 2.
The slot number (1-6) that contains the CMG card.
To designate VoIP 1:1 is used.
Channel number for the router is 1-48, range or all
CLI Commands
set
5-181