Set (Router) Ntp - Black Box Compact T1 MT850A User Manual

set (router) ntp

Use the set (router) ntp command to setup Network Time Protocol (NTP) parameters.
set (router) ntp enable/disable
Use the set (router) ntp enable/disable command to enable/disable NTP processing.
Syntax:
Example:
{rtr_card-addr}
The slot number (1-6) that contains a Router (IP or CMG) card.
{enable|disable}
enable
disable
set (router) ntp poll
Use the set (router) ntp poll command to specify polling of the NTP server every defined
number of seconds.
Syntax:
Example:
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{seconds}
The number of seconds between polls. Seconds range is 16 to 1024. Default is 16.
Compact T1 - Release 6.1
set {rtr_card-addr} ntp {enable|disable}
set 1 ntp enable
The example will enable NTP processing on the Router card in slot 1.
Enable NTP processing
Disable NTP processing
set {rtr_card-addr} ntp poll {seconds}
set 1 ntp poll 120
The example will Poll the Network Time Protocol server every 2 minutes, for
the Router card in slot 1.
CLI Commands
set
5-127