Black Box Compact T1 MT850A User Manual page 202

Multi-service delivery terminal
Table of Contents

Advertisement

CLI Commands
set
set (router) mgcp package default
The set (router) mgcp package default is an interoperability command to set the default
signal/event package to be used for the IETF version of MGCP. The default for this default
is the DTMF (D) package. In the NCS version of MGCP, the default package is always the
Line (L) package. This parameter does not apply to the NCS version of MGCP, whose
default package is always the Line (L) package. For whichever package is made the
default, the package name is not required in the softswitch-to-gateway MGCP parameter
lines R, S, or T. In the gateway-to-softswitch O (observed events) parameter line, if the
default package is set to DTMF(D), no package name is prepended to reported dialstring or
digit events. In all other cases for observed events O, the package name is prepended (i.e.
the L and G package names are always prepended in observed events). This command
applies to the CMG Router card only.
Syntax:
Example:
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
{d|g|l}
d
g
l
5-118
set {cmg_card-addr} mgcp package default {d|g|l}
set 1 mgcp package default g
The example will set the MGCP General package the default signal/event
package, for the CMG card in slot 1.
Make the DTMF (D) package the default
Make the General (G) package the default
Make the Line (L) package the default
Compact T1 - Release 6.1

Advertisement

Table of Contents
loading

Table of Contents