Table of Contents
Advertisement
set (router) mgcp keepalive
Use the set (router) mgcp keepalive command to configure a keep-alive timer that will
cause the CMG to resend RSIP restart messages on expiration. When enabled, this
countdown timer is reset every time an MGCP message is received from the call agent. On
expiration, the CMG will react by starting periodic transmission of a wildcard RSIP restart
MGCP message to each of the configured call agents until it is acknowledged. This
command takes effect immediately.
Syntax:
Example:
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
{disablements}
disable
minutes
Compact T1 - Release 6.1
set {cmg_card-addr} mgcp keepalive {disablements}
set 1 mgcp keepalive 5
The example will set the MGCP keep-alive timer to 5 minutes for the CMG in
slot 1.
Disables the MGCP keep-alive timer. Default is disable.
The number of minutes for the countdown timer. Range is 0 - 255,
where 0 will also disable the timer.
CLI Commands
set
5-117
Advertisement
Table of Contents
